branch: BlendCurve testing #53
Closed
Conversation
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
Build experimental snaps for FreeCAD/FreeCAD#7339 CC @Matteo-Grellier @tomate44
|
needs the .git suffix in source |
|
I don't think the PR is even compiling. |
|
Build has been retriggered |
This comment was marked as outdated.
This comment was marked as outdated.
|
Build has been retriggered |
7 tasks
|
Closing as target commit has been merged upstream FreeCAD/FreeCAD#7339 |
|
A build from commit 93330b2 has been published to channel edge/pr-53 as revision 232. Installation instructions # Note: not all distros require 'sudo'
$ sudo snap install --channel=edge/pr-53 freecad
# If you already have the freecad snap installed
$ sudo snap refresh --channel=edge/pr-53 freecad
# Experimental: Parallel install (see https://github.com/FreeCAD/FreeCAD-snap/blob/master/docs/index.md#parallel-installs)
$ sudo snap set system experimental.parallel-instances=true
$ sudo snap install --channel=edge/pr-53 freecad_pr53
$ freecad_pr53 # Run it
# To switch back to preferred snap (swap out 'edge' for 'stable' if necessary)
$ snap refresh freecad --channel=edge freecad |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
Build experimental snaps for FreeCAD/FreeCAD#7339
CC @Matteo-Grellier @tomate44