You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
This is a minor bug as there is a work around, see the forum post above
Steps to reproduce
To create the window I had a standard window in first, then changed the sketch to a custom one.
Often this works fine, as the example attached did until I made it higher,then all changes to the image seem to not do anything. I cannot reliably reproduce the behaviour, although it has happened before.
Issue imported from https://tracker.freecad.org/view.php?id=4575
Original report text
When putting a window in a roof, the hole often works, but at times it produces the wrong hole.
https://forum.freecadweb.org/viewtopic.php?f=23&t=56018&p=481865#p481865
Additional information
This is a minor bug as there is a work around, see the forum post above
Steps to reproduce
To create the window I had a standard window in first, then changed the sketch to a custom one.
Often this works fine, as the example attached did until I made it higher,then all changes to the image seem to not do anything. I cannot reliably reproduce the behaviour, although it has happened before.
FreeCAD Info
Other bug information
Discussion from Mantis ticket
Comment by Kunda1 2021-02-26 12:12
Assigning to yorik
The text was updated successfully, but these errors were encountered: