[Path] - Add Turning / Lathe Base Support #3951
Merged
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
This PR adds some base features to the path workbench to allow development of the Turning features as a FreeCAD Addon.
https://github.com/dubstar-04/FreeCAD_Turning_Addon
The intention is to allow users to install the Turning addon through the FreeCAD addon installer, allowing simple access to test and contribute to the development of the Turning features without needing to build FreeCAD from source. Development of Turning features has currently stalled, I hope that easy access to the addon will encourage myself and other to move it forward.
git pull --rebase upstream master
./bin/FreeCAD --run-test 0
issue #<id>
orfixes #<id>
where<id>
is the associated MantisBT issue id if one existsForum Thread: https://forum.freecadweb.org/viewtopic.php?f=15&t=30563