AZ Touch + ESP32-WROOM-32 #131
Replies: 8 comments 24 replies
-
What a great find!! |
Beta Was this translation helpful? Give feedback.
-
The whole tft_espi configuration is done via the ini file. The backlight can also be set in the web interface. If that works, we'll need to add the pin as a valid option in the web UI too. |
Beta Was this translation helpful? Give feedback.
-
could you test following config in a .ini file in user_setups/active ? [env:arduitouch-esp32_ili9341]
extends = esp32
board = esp32dev
build_flags =
${env.build_flags}
${esp32.build_flags}
;region -- TFT_eSPI build options ------------------------
${lcd.lolin24}
${esp32.vspi} ; Use VSPI hardware SPI bus
-D TFT_DC=4
-D TFT_CS=5
-D TFT_RST=22 ; RST
-D TFT_BCKL=15
-D TOUCH_CS=14
;endregion
;region -- Library options -------------------------------
lib_deps =
${env.lib_deps}
${esp32.lib_deps}
lib_ignore =
${env.lib_ignore}
${esp32.lib_ignore}
;endregion |
Beta Was this translation helpful? Give feedback.
-
No, I did not. |
Beta Was this translation helpful? Give feedback.
-
Beta Was this translation helpful? Give feedback.
-
Hi! HomeAssistant integration also works but I am failing with a custom image for DTH22 Sensor used on GPIO32. |
Beta Was this translation helpful? Give feedback.
-
A dedicated page for the AZ-Touch has been added to the documentation. |
Beta Was this translation helpful? Give feedback.
-
I have similar setup: AZ-Touch Mod and ESP32 Dev KitC V4 WROOM-32. Firmware loads ok, I can get IP, but after closing IP dialog by clicking OK, there is only text 'plate' in upper left corner. Log:
|
Beta Was this translation helpful? Give feedback.
-
I have the following: https://www.az-delivery.de/nl/products/az-touch-wandgehauseset-mit-touchscreen-fur-esp8266-und-esp32
In arduino IDE i use #include <SPI.h> and #include <TFT_eSPI.h>
I have modified User_Setup.h of eSPI library to the following:
I would like to custom build / compile openhasp to work like this. What do i need to modify for this ? I have tried the same User_Setup.h in openhasp
Also have the following in the ini file:
But the display does nothing (webinterface works). In the log / terminal i see a line that the backlight pin is not configured and has to be done in webinterface but i can't set it to PIN 15 / inverted (LOW)
Is their a solution ?
Beta Was this translation helpful? Give feedback.
All reactions