Skip to content

Bill of Materials (12 Bit Extender)

IanSB edited this page Jun 7, 2021 · 14 revisions

Introduction

This page lists the parts needed by the 12 bit Extender board for use with the 12 bit main board (by IanB)

The 12 bit boards have the same 8 bit header as the earlier 8 bit boards with the extra 4 bits on another header as there isn't enough room for the full 12 bit header so the extender consolidates this and brings all 12 bits, sync and power outside the case on a single connector. This is only required for computers that have to pick up all 12 bits internally.

The latest schematics are here:

The latest gerbers are here:

12 bit extender parts

Part Description Supplier Quantity Part Ref Min Order Notes
Schottky diode MBR130LSFT1G Farnell 2463407 1 off D1 5 SOD-123FL package. Alternatively bypass using the solder bridge JP5
Samtec SSW-106-02-T-D-RA 2x6 way 0.1" female right angle PCB Header Farnell 2779580 1 off P1 1
Samtec TLW-104-06-T-S 1x4 way male header RS 198-2815 1 off P2 1 Long side of pins goes in PCB
Samtec TLW-101-06-T-S 1x1 way male header RS 198-2806 2 off P6, P7 1 P6 & P7 should be trimmed flush with the plastic to act as support/spacers (see photo)
16 Way IDC header (vertical) Farnell 1554029 1 off P4 1

Cable assembly

The cable assembly will vary with each board and will require a matching IDC connector and ribbon cable plus an appropriate connector for the computer.

Note after trimming their pins as mentioned above, P6 and P7 act as feet and rest on top of the Pi zero's camera connector to stop P2 on the board from falling out of its socket if you push down on the external connector which might result in the bottom of the board shorting against components on the Pi zero.

Clone this wiki locally