The EZ-BT Mesh Evaluation Kit (CYBT-213043-MESH) enables you to evaluate SIG Mesh functionality and features using the EZ-BT AIROC™ Module CYBT-213043-02. The CYBT-213043-02 EZ-BT AIROC™ Module is an integrated, fully certified, 12.0 mm x 16.61 mm x 1.70 mm, programmable dual-mode Bluetooth® module designed to reduce your time-to-market. The CYBT-213043-02 module utilizes the Infineon CYW20819 silicon device.
Each mesh board included in the CYBT-213043-MESH kit features following:
- CYW20819-based dual-mode (LE/BR/EDR) Bluetooth® 5.0-compliant fully certified module (CYBT-213043-02)
- 1MB External Serial Flash
- FCC, ISED, MIC, and CE Certified Module on board (CYBT-213043-02)
- Bluetooth® 5.0 with SIG MESH Qualified Module (CYBT-213043-02)
- USB connector for power, programming, and USB-UART bridge
- CYBT-213043-02 certified module based on CYW20819
- Sensors - Thermistor, Ambient Light Sensor (ALS), and PIR motion sensor
- RGB LED
- User switch
- Power measurement jumper
- Coin-cell battery holder (battery is not included in the kit)
- Option to select between USB power and coin-cell as power source
- On-board programmer and USB-UART bridge
The CYBT-213043-02 module utilizes the Infineon CYW20819 silicon device. CYW20819 is an ultra-low-power (ULP) and highly integrated dual-mode Bluetooth® 5.0 qualified device. The CYW20819’s low-power and integration capability addresses the requirements of both battery- and wall-powered applications that require Bluetooth® LE mesh, such as sensor nodes, locks, lighting, blind controllers, asset tracking, and many more Smart Home applications.
CYBT-213043-MESH kit is supported in ModusToolbox™ IDE 2.0 with BTSDK 2.0 or later. Infineon provides a number of code examples and snip codes for mesh functionality on GitHub. These code examples that allow you to implement real-life mesh application such as a dimmable light (bulb), dimmer and a thermometer and likes just in few minutes. These code examples can be searched and imported within ModusToolbox™.
Max UART baud rate is 1M. Use baud rate of 115200 for Client Control.
External 32 kHz LPO is used by default. To operate without external LPO, set USE_32K_EXTERNAL_LPO=0 on the make command line or edit the default value in CYBT-213043-MESH.mk.
- 4x Mesh evaluation boards - Inclusion of four board allows to evaluate a real mesh network with just one kit
- 4x USB-A to micro-B cable
- 1x Quick Start Guide
For more information, see CYBT-213043-MESH