You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
when travelling on a LOADED vessel at high warp speeds the habitats are not pressurized properly due to calculation errors on high warping speeds (50x and above) as a result these 2 things are happening:
when the pressure reaches nearly 100kpa it slows down and consumes excessive nitrogen(higher warp)
pressure level loops between 90kpa and 70kpa(lower warp)
if a high pressure of about 100.9 is reached it will remove all pressure going back to 0kpa (when fluctuating between warps)
AND also even when inflating the habitat when the vessel is unloaded loading it backdrops the pressure down to 70kpa
all these problems cause constant unrealistic pressure loss and unnecessary nitrogen consumption when inflating habitants also warping down seems to remove some atmosphere
the problem doesn't occur on lower warp speeds-slower pressurization
replication: build a large vessel (habitat disabled) and launch it into space with a few pressure control modules and then high warp and watch the habitat pressure gauge from the menu under high warp speed
The text was updated successfully, but these errors were encountered:
when travelling on a LOADED vessel at high warp speeds the habitats are not pressurized properly due to calculation errors on high warping speeds (50x and above) as a result these 2 things are happening:
AND also even when inflating the habitat when the vessel is unloaded loading it backdrops the pressure down to 70kpa
all these problems cause constant unrealistic pressure loss and unnecessary nitrogen consumption when inflating habitants also warping down seems to remove some atmosphere
the problem doesn't occur on lower warp speeds-slower pressurization
replication: build a large vessel (habitat disabled) and launch it into space with a few pressure control modules and then high warp and watch the habitat pressure gauge from the menu under high warp speed
The text was updated successfully, but these errors were encountered: