Home

Welcome to the Drogon Instructions! Here, you'll find out how to assemble Drogon paper model.

And you can collaborate, of course!

Tools and material you'll need

Completely read these instructions before cutting. Make sure you understood all instructions steps
Detach parts carefully as they are needed
Avoid over application of glue! This may cause paper to wrinkle. Use a paint brush to apply glue on parts
In some parts, you'll notice some white areas and yellow lines showing how pieces should line up when glued
When you cut paper, white edges will be apparent. Use a marker or pencil to color these edges, before gluing them
Mountain fold means printed surface should be on the outside
Valley fold means printed surface should be on the inside
When building, be sure the glue dries completely before proceeding to the next step
When joining opened parts, like partial cones and cylinders, start gluing two tabs. When completely dry, glue remaining tabs
There is an edge where you close the cylinder or cone. Let's call it the guide edge. Use this guide edge as an alignment mark when glueing one part to another.
Cut some stripes from ´textures´ file to hide some joints