The base configuration can capture the following:
- temperature / pressure / humidity
- PM2.5
The configuration consists of:
- a 3.8" 3 opening wxOrb (non-imprint)
- a basic shield housing
- a basic AQ housing (2 part hooded)
- 1 PVC adapter
- 4 PVC rings
- 2 closed endcaps
- 1 vented endcap
Print time is estimated at 37.5h on Ender 3 S3 at 60mm/s, PLA+.
| Part | Location | Est. Print Time | Notes |
|---|---|---|---|
| 3.8" Housing (3 opening) | ./housing/orb38_housing_3open.stl | 12h | 20-25% infill; positioned thread side down |
| basic shield housing ( for BME680) | housing (MF) ./shield/mushroom_shield_MF.stl | 6h | print cup side up / (M) thread down; use limited support to end of thread for stability; 25% infill |
| a basic AQ housing (2 part hooded) | base (M) ./aq/aq_grill_base_M.stl; vented lid ./aq/aq_grill_lid.stl |
base: 4h; lid: 2h | base: print on side with tree support (@2% infill), 20-25% infill everywhere else; lid: print grill side down, 20-25% infill |
| PVC adapter | ./pvcadapter/knurled_pvc_adapter_M.stl | 3h | print thread side up, 30-40% infill for maximum strength |
| PVC Rings (4x) | ./solarpanel/solarpanel_ring_clamp_11mm.stl | 6h | print flat side to plate, 30-40% infill for maximum strength |
| Closed endcaps (2x) | ./endcaps/closed_endcap.stl | 3h | flat (cap) side to plate, 30-40% infill for maximum strength |
| Vented endcap (1x) | ./endcaps/vented_endcap.stl | 1.5h | flat (vented) side to plate, 30-40% infill for maximum strength |
- openIoTwx Hub : https://github.com/NCAR/openiotwx-hub