02.2. Settings (V0.6~)
- it disables Tello drone registration for devices with WiFi scanning problem
- connects Tello with the current connected WiFi as official Tello app does
- register Tello drone for auto-connecting
- Android Location service should be turned on to scan WiFi
- Stick position is MODE2 (LEFT:Yaw/Throttle, RIGHT:Roll/Pitch)
- Yaw/Throttle position selection (not mode change)
- Yaw/Throttle and Roll/Pitch position is swapped
- easy for gyro sensor control
- gyro sensor sensitivity
- higher, more sensitivity
- register Parrot FlyPad or GameSir T1D controller
- it can be activated in the main controller screen
- mapping the bluetooth/usb controller buttons to the functions
- ① ~ ⑦ functions are matched with number buttons on screen
- L2(LT) / R2(RT) buttons are used as combination buttons (like shift keys)
- L2(LT) / R2(RT) buttons can not be used alone
- available buttons for supported controllers
- below buttons can be used alone or combined with L2(LT) / R2(RT)
- MP4 : general use (default)
- h.264 : raw video stream for debugging
- enable recording audio from device mic.
- only available with MP4 video format
- Enable/Disable "Text To Speech"
- this switch is enabling/disabling video processing such as face tracking (turn it on for face tracking)
- video processing requires much cpu power and specific feature Android supports
- if the device does not support required feature, this is turned off internally and face tracking is deactivated
- if your device is slow when it is on, turn it off
- face detection is processed with Google vision library
- Google Play Services has probably not finished loading the required files.
- Usually, the download is taken care of at application install time, but this is not guaranteed.
- In some cases the download may be delayed.
- if the library checking fails
- disconnect from the drone and connect to the internet
- go to playstore and see there is an update about "Google Play Services", if so update it
- if the issue is still reproduced
- go to applications in the Android settings and find "Google Play Services"
- click storage and clear cache
- go to aTelloPilot and click the "check" button, it will initiate Google Play Services to download the library
- after several minute, click the button again to see if it is working well
- RC outputs can be tuned with 'Rate' and 'Expo'
- 'Rate' tunes the slope of the line or curve
- 'Expo' tunes the variation points of the curve
- max 'Rate' and min 'Expo' will make input:output ratio to 1:1
- no modification for output
- Normal / High
- can change battery warning level (10% ~ 50%)
- can change camera exposure
- can change video bitrate (Auto, 0.5Mb, 1Mb, 1.5Mb, 2Mb, 3Mb, 4Mb)
- can change altitude limit from 1m ~ 30m)
- saving flight logs for analysis
- change video mode when it starts up.