You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Device(please complete the following information):
Device: Bridge6
Firmware version: v1.1.0beta2
Hardware version: v1.0.1
Describe the bug
When copying a bank without tap tempo on a switch to a bank with tap tempo on the switch, the light stays on (example: Bank 3, switch 3 is set to sequential and bank 1 switch 3 is set to tap tempo...after copying bank 3 over bank 1, the tap tempo light continues to blink until going into "Config" and re-saving the mode of the switch)
To Reproduce
Steps to reproduce the behavior:
Create a bank with a switch configured for Tap Tempo2.
Create a bank with the same switch configured to something else (sequential in my case)
From Bank 1, copy bank 3 over bank 1
Expected behavior
All lighting behavior would match the mode of the switch after it was copied and not emulate the old configuration of the switch
Screenshots
Provided upon request
The text was updated successfully, but these errors were encountered:
Device(please complete the following information):
Describe the bug
When copying a bank without tap tempo on a switch to a bank with tap tempo on the switch, the light stays on (example: Bank 3, switch 3 is set to sequential and bank 1 switch 3 is set to tap tempo...after copying bank 3 over bank 1, the tap tempo light continues to blink until going into "Config" and re-saving the mode of the switch)
To Reproduce
Steps to reproduce the behavior:
Expected behavior
All lighting behavior would match the mode of the switch after it was copied and not emulate the old configuration of the switch
Screenshots
Provided upon request
The text was updated successfully, but these errors were encountered: