You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
When using analysis features during a tour, there doesn't seem to be an elegant way to enable the measurement and analysis tools panels for only one or two steps during a tour. If it is enabled as visible for one step of the tour then it is visible for the entire tour (except when there is an article present in the step). This gets quite busy with four bottom panels visible when it's not always necessary. This seems to be only an issue with the measure tool. Could it be adjusted so that the analysis tool and measurement panel is activated and captured by step rather than by the entire tour? Again, it is necessary specifically for measurement because the measurement panel does show the values in the panel. But when you use slice or other views you can hide the panel, which is good.
An alternative solution might be to keep the panels hidden but have a pop-up of the measurement values in the Explorer Window.
The text was updated successfully, but these errors were encountered:
When using analysis features during a tour, there doesn't seem to be an elegant way to enable the measurement and analysis tools panels for only one or two steps during a tour. If it is enabled as visible for one step of the tour then it is visible for the entire tour (except when there is an article present in the step). This gets quite busy with four bottom panels visible when it's not always necessary. This seems to be only an issue with the measure tool. Could it be adjusted so that the analysis tool and measurement panel is activated and captured by step rather than by the entire tour? Again, it is necessary specifically for measurement because the measurement panel does show the values in the panel. But when you use slice or other views you can hide the panel, which is good.
An alternative solution might be to keep the panels hidden but have a pop-up of the measurement values in the Explorer Window.
The text was updated successfully, but these errors were encountered: