You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
The wiring harness of our car routes low voltage wiring to the cars powered components:
MABX controller
Front power pcb
Rear power pcb
AMS
Power is routed from the AMS to the isolation board and IMD. Power is routed from the rear power distribution board to the ICE system.
This project will require a project proposal after initial research is completed and method of modelling harness is determined.
Outcomes
We need a BOM and wiring diagram for the wiring harness.
The BOM should contain the following for each wire:
Pin labels
Gauge
Length
The diagram should clearly show what sections of the harness are routed where.
Constraints
This is a critical task in getting our vehicle ready for testing. Deadline for design is Jan 5th 2017. Deadline for fabrication and installation is Jan 19th 2017.
Related Issues
Altium schematic will be provided as soon as FPD, RPD, AMS, Isolation, Telemetry systems are solidified with respect to their connections.
Wire destinations will also be provided at this time.
Steps to reproduce behavior
Research various wiring harness softwares.
Look into Siemens add on for Solidworks
Learn to route wires, produce appropriate BOM and diagrams
Once data is available continue with final modelling of harness
Route wires in the 2015 Frame CAD model
Create BOM etc.
The text was updated successfully, but these errors were encountered:
Context
The wiring harness of our car routes low voltage wiring to the cars powered components:
Power is routed from the AMS to the isolation board and IMD. Power is routed from the rear power distribution board to the ICE system.
This project will require a project proposal after initial research is completed and method of modelling harness is determined.
Outcomes
We need a BOM and wiring diagram for the wiring harness.
The BOM should contain the following for each wire:
The diagram should clearly show what sections of the harness are routed where.
Constraints
This is a critical task in getting our vehicle ready for testing. Deadline for design is Jan 5th 2017. Deadline for fabrication and installation is Jan 19th 2017.
Related Issues
Altium schematic will be provided as soon as FPD, RPD, AMS, Isolation, Telemetry systems are solidified with respect to their connections.
Wire destinations will also be provided at this time.
Steps to reproduce behavior
Once data is available continue with final modelling of harness
The text was updated successfully, but these errors were encountered: