Create alfawise_u30.def.json

[NicolasNSSM]

I basically took the base from Samuel Pinches U20 def and compiled it with the old Cura .ini given by Alfawise on the SD card.

I don't know anything about Cura config so double check it real good!

I'll test it further tomorrow as for now I don't have access to my printer: TESTED OK

[NicolasNSSM]

It works!

[pinchies]

Thanks for implementing this for the U30. You may also want to change the start gcode slightly if you have problems with the prime line hitting the bed clips. You can change the X60 and X100 move commands to be Y60 and Y100 commands instead. I've just updated the U20 file here: #5093

[NicolasNSSM]

@pinchies I don't have any X60 or X100 in my command as there wasn't any in the .ini file

[pinchies]

@pinchies I don't have any X60 or X100 in my command as there wasn't any in the .ini file

Maybe have a look in this file, so you can compare the start gcode: #5093
located in resources/definitions/alfawise_u20.def.json

[NicolasNSSM]

Of course I did, I saw what you updated but as I don't have any of these in my code and I don't even know what it means, I'm not sure what to do?! Just copy your updated part without deleting anything?
Honestly, if you know how to do it, you'll be faster pushing a commit over it! :D

[pinchies]

Here you go - I don't know how to create a new pull request over yours, this is the one file that needs to be changed to add a prime line. Would you like to try to replace the contents of your file with this one please?
alfawise_u30.def.json.zip

[NicolasNSSM]

Done! ;)

[nallath]

For our reference; CURA-6081