IBM UrbanCode Deploy and Build LogiGear TestArchitect Plug-in

---

License

This plug-in is protected under the Eclipse Public 1.0 License

Compatibility

The IBM UrbanCode Deploy automation plug-in uses the TACommandLine.jar library.
This plug-in requires version 6.1.1 or later of IBM UrbanCode Deploy.

Installation

The packaged zip is located in the releases folder. No special steps are required for installation.
See Installing plug-ins in UrbanCode Deploy. Download this zip file if you wish to skip the
manual build step. Otherwise, download the entire LogiGear-TestArchitest-UCB-UCD and
run the "gradle" command in the top level folder. This should compile the code and create
a new distributable zip within the releases folder. Use this command if you wish to make
your own changes to the plug-in.

History

Version 7
    - Separated build process for Build and Deploy.
Version 6
    - Initial open source release.
    - Merged the two IBM UrbanCode Build and Deploy specific steps in two shared steps.

How to build the plug-in from command line:

1. Navigate to the base folder of the project through command line.
2. Make sure that there is build.gradle file, and then execute gradle command.
3. The built plug-in is located at build/distributions/logigear-testarchitect-xxxx-open-vdev.zip

Note: The gradle -Pbuild=y command will build the IBM UrbanCode build specific plug-in. While gradle will build the plug-in for IBM UrbanCode Deploy.