Klipper and SuperSlicer profiles for Voron V2.4928

This is the configs of my Voron 2.4 300 mm3 Serial:V2.4928

Be aware I see my config as WIP and it can and will change any time. I normally do only checkin stuff that is tested and run with the base klipper branch but I test also klipper PRs so it can happen that I oversee that from time to time and have stuff here that needs a special PR from klipper.

My Setup

• LDO 300 mm Voron 2.4 kit
• Klicky
• Stealthburner CW2
• Oseq Safe Sheet
• Genuine Gates brand pulleys/idlers in gantry
• Rapido HF
• Bondtech CHT 0.4 nozzle
• Pi cam
• Nozzle brush
• Bed fan mod
• GE5C mod using EGLM-05 - IGUBAL

Bed mesh tips and tricks

guide

My Reddit posts

First layer and Bed Mesh

https://www.reddit.com/r/VORONDesign/comments/119yp3f/bed_mesh_first_layer/

Superslicer profiles

Derived from Ellis PIF profiles, but tuned for my setup and filaments.

Disclaimer: Usage of this printer config happens at your own risk!