home-assistant-config

Config-files and settings for my Home Assistant and smarthome. So that I easily can set it up if I break my SD-card (Again). Or drown my Rpi (Again). Or fry my Hue-hub (Again).

Hardware

• Raspberry Pi 4
• 5.1V 3A power adapter (Important to use a proper power adapter!)
• Slide case (Be careful not to break your SD-card when sliding it together...)
• Sonoff Zigbee 3.0 USB dongle
• 20 cm USB-extender for Sonoff
• Philips Hue hub
• Futurehome hub V1.0 (Zwave/enocean)
• USB to SATA
• SSD Drive

Installation of Home Assistant OS to SSD

1. Download and install Rasperry Pi imager: https://www.raspberrypi.com/software/
2. Run Pi Imager, select OS, Misc utility images, Bootloader, USB Boot. Select SD-card and Write
3. Put SD-card in RPi4, power up RPi, wait 30 seconds, remove power, remove SD-card and throw it away
4. Connect USB to sata with SDD to computer, run Pi Imager again
5. Select OS, Other specific-purpose OS, Home assistants and home automation, Home Assistant, Home Assistant OS 9.4 (RPi 4/400), select SSD and Write.
6. Connect USB to sata to RPi USB 3.0-port, power up RPi.
7. Go grab a coffee, and the connect to homeassistant.local:8123 and restore backup.

Add-ons

• HACS
• Auto Backup from HACS
• Samba share - Folder with backup-files from Auto backup mounted on computer which syncs to Jottacloud
• Futurehome2mqtt - Expose (some of) the devices in Futurehome to HA
  • Connected to Futurehome-hub
• Zigbee2MQTT
  • Bridged to Futurehome, se Mosquitto.conf
• Leaf2mqtt - To get battery-status from Nissan Leaf
• Mosquitto broker
  • Bridge to Futurehome, broker for Zigbee2MQTT

Configuration

• Configuration.yaml
• Automations.yaml