add another flash chip for hallowing m0 express #8646
Merged
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
A small number of hallowing m0 express boards were manufactured with an incorrect flash chip (2MB instead of 8MB).
If you have received one of these boards, contact support AT adafruit DOT com for refund/replacement options. They can be identified by the marking "25Q16JVSIQ" on the 8-leg Winbond flash chip near the switch -- the bottom chip highlighted in the image below.
However, there's no need to make these boards e-waste. At the cost of a few bytes of flash, we can make them work with this simple update, as tested by a user who received one of the incorrectly manufactured units.