no message

docs/q-775-spyder-operation.rst

@@ -79,15 +79,15 @@ After changing a parameter, you must select **"Write"** to save the parameter to
 
   4.3  To arm the aircraft, hold the left control stick fully down and to the right.
 
-  .. tip:: If the aircraft will not arm please see: `[Understanding ArduPilot mandatory onboard pre-arm safety checks] <http://ardupilot.org/copter/docs/prearm_safety_check.html>`_
+    .. tip:: If the aircraft will not arm please see: `[Understanding ArduPilot mandatory onboard pre-arm safety checks] <http://ardupilot.org/copter/docs/prearm_safety_check.html>`_
 
   4.4 The aircraft will arm and props will start spinning.
 
   4.5 To take off, quickly raise the throttle and release when the aircraft reaches desired elevation.
 
   4.6 Move SWD to the down position to raise landing gear.
 
-  .. tip:: The highest risk of a crash is just before and after takeoff, when in close proximity to the ground.
+    .. tip:: The highest risk of a crash is just before and after takeoff, when in close proximity to the ground.
 
 
 5. Manual Landing
@@ -119,7 +119,7 @@ After changing a parameter, you must select **"Write"** to save the parameter to
 
   6.5 When you switch the aircraft into `AUTO` flight mode, the vehicle will Arm itself, take off and proceed with the mission.
 
-  .. tip:: You can change flight modes at any time during an Auto mission to regain control of the aircraft.
+    .. tip:: You can change flight modes at any time during an Auto mission to regain control of the aircraft.
 
 7. Auto Landing
 ---------------