-
Notifications
You must be signed in to change notification settings - Fork 1
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
alternative charger #1
Comments
I don't know, I have to build a device again, as I have blow up mine with a Battery Pack, which goes up to 19V by pressing the Power button a short time, and long time to turn on / off. |
thank you, |
Yes, if you have the result, post it here, because somebody may find this, because of the same question ;-) |
Hello, i don't have the result, no amp meter, i work again in remote. |
[edit: I thought I'm reply to a private notification... But don't matter]
Hi
Thanks for the Feedback!
From where are you? Depending on
this, the shipping might cost more than the Board...
I would be much more interested in
images, you added Charging, did you already build a case /
connectors?
By the way I use mine battery
Powered, therefore Charging is no option ;-)
My Email Address / I thought this is
public anyway... But github uses Some anonymize address...:
andreas_b123@bluewin.ch
Andreas
|
hello, my charger is dead and i use your board with a led driver for charging.
thank for all, all is ok my landroid come back to life ;)
i have adapt for command on jlpcb
https://easyeda.com/feiltom/libreductioner
i want to adapt for include charging section to the board. you say on forum 1w for 12v ?
this make 83ma ? on peak also ?
with lockdown i don t have access to my mesure device.
have a. good day.
The text was updated successfully, but these errors were encountered: