You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I just installed the 5.4.0 firmware on my i3+ This is my first install of ADVi3++, but I believe I did everything right. Flashed the 5.4.0 LCD firmware via a 2GB SD card and the 5.4.0 Mainboard 5.1 firmware via Cura and a USB cable. I was testing functions and found that I could adjust the beeper settings but no matter which function was toggled on the beeper would not sound. I found that when I adjust the beep duration and hit the checkmark it does not save and defaults to 0ms. Similarly, if I adjust the numerical values in the screen dimming options they do not save.
Edited to add: In the beeper settings, it will play the beep of appropriate duration as a preview when I hit the “+” or “-” buttons or enter a number manually and hit the the “ok” button, but as soon as I hit the checkmark to save the value is reset to 0.
Expected behavior
Settings should be saved.
Actual behavior
Settings are not saved.
Steps to Reproduce
Go to Settings / LCD
Change any parameter
Tap on the checkmark
Go back in LCD
Settings have not been changed
Same thing for Beeper but in addition, the duration is set to 0.
Version of ADVi3++ Firmware
5.4.0
Printer model
Wanhao Duplicator i3 Plus
Mods
No response
Bed Leveling
No response
Your Slicer
No response
Host Software
No response
Additional information & file uploads
No response
The text was updated successfully, but these errors were encountered:
Did you check that your report is not a duplicate?
Yes, I have checked and this is a new bug not previously reported.
Bug Description
From https://community.advi3pp.com/t/5-4-0-lcd-doesnt-save-dimming-or-beeper-settings/4330
Expected behavior
Settings should be saved.
Actual behavior
Settings are not saved.
Steps to Reproduce
Same thing for Beeper but in addition, the duration is set to 0.
Version of ADVi3++ Firmware
5.4.0
Printer model
Wanhao Duplicator i3 Plus
Mods
No response
Bed Leveling
No response
Your Slicer
No response
Host Software
No response
Additional information & file uploads
No response
The text was updated successfully, but these errors were encountered: