You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I will enhance the documentation. In the meantime, here is a description from Marlin’s documentation (Babystep | Marlin Firmware):
Apply babysteps to one or more axes using current units. Offsets applied with M290 aren’t added to the current coordinates, but are intended for making small adjustments, especially in the Z axis, at the start of a print.
Note that when BABYSTEP_ZPROBE_OFFSET is enabled, M290 also modifies the Probe Z Offset (with no immediate effects). The new Z offset applies to successive probing operations, and can be saved with M500. This behavior is means to coincide with the LCD Menu replacing “Z Babystepping” with “Babystep Z Probe Offset.” To avoid this side-effect, use M290 P0 or leave ?BABYSTEP_ZPROBE_OFFSET disabled.
For ADVi3++, BABYSTEP_ZPROBE_OFFSET is enabled. Pressing the checkmark triggers a M500.
When accessing updated print settings panel I don't understand some functions which are not described in the manual https://manual.advi3pp.com/en/touch-panel-guide/print/print-settings
The panel has 2 settings.
The manual has reference to baby stepping, but it is not clear
Please make it more clear as it is unusable for me at the moment w/o support
The text was updated successfully, but these errors were encountered: