You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hello,
it would be amazing, if the klipper estimator could use the config.js in the case the 3D Printer cannot be found in the network.
Should not be difficult to integrate.
Greetings
The text was updated successfully, but these errors were encountered:
This is already supported, but not currently documented. I will get to documenting it eventually, but I don't currently have the time for it. You can run klipper_estimator -h to see all supported options.
Hello,
it would be amazing, if the klipper estimator could use the config.js in the case the 3D Printer cannot be found in the network.
Should not be difficult to integrate.
Greetings
The text was updated successfully, but these errors were encountered: