Classroom Automation

• Classroom Automation using Arduino.
• Automating lights and fans of a classroom according to Timetable.
• Prerequisites : Good Knowledge of Database and Python Tkinter.
• Tkinter Module is used for GUI.

Python Modules Used:

• Tkinter
• mysql.connector
• datetime
• pyserial

Softwares Used:

• WampServer For Database Management.
• Arduino IDE.
• Python 3.6.4 IDLE.

Hardwares Used:

• Arduino Mega 2560.
• Single Channel Relay Board (5V).
• Cable For Arduino UNO/MEGA (USB A to B).
• Male to Female Jumper Wires.

Connections:

• Ground: Connect to the Arduino's GND pin.
• 5V Vcc: Connect to the Arduino’s 5V pin.
• Signal: Connect to the Arduino's digital pin (pin 7).

Note:

• Mainfiles won't run if you haven't connected Arduino to your PC.
• You need to change the Com port in the python file according to your PC.
• There are two types of table in database, one for switching relay on or off every minute and the other one for every hour.
• If you want to run for every minute then run MainFile2 and for every hour run MainFile and change the table name in python file accordingly.