Name of an existing input to use in a script

[Plotter123]

Hello all,
I try to write a script, and want to use an existing input, in this case it is called "Analog1" in the Web Interface or
MQT: tele/tasmota_4A8E44/SENSOR = {"Time":"2023-07-30T20:35:42","ANALOG":{"A1":1751} in the console. This input is located on GPIO34 of the ESP32 Board.

What is the correct name to use this value in a script? According to the examples in the script documentation where a temperature is like this "temp=BME280#Temperature" I tried "Wert=ANALOG#A1" without success. I also tried to read out directly the raw signal with
"print level of gpio %pin[34]%" but the output was always zero.

Are there further documentations I missed to find this out myself, or is there the possibility to have more informations in the console log files?

Any help is appreciated, Georg

[Plotter123]

Found it out myself, maybe the solution helps someone else:
Wert=ANALOG#A1 was OK, but I missed defining Wert in the >D Section, the following works:

D
Wert=0
T
Wert=ANALOG#A1
S
print %Wert%