You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Currently BS doesn't allow any part of an object to move below the plate plane. Allowing objects to go below the plate, like in Cura, will save time in situations such as testing out overhang, or reprinting part of a big model that previously failed at a certain height. In these cases, the lower part of the model doesn't need to be printed.
The text was updated successfully, but these errors were encountered:
This would be a good feature but it should also allow the part to be lifted from the build plate to create a gap.
This allows supports to go under a part when the second or third layer are too close to the build plate for supports.
Currently BS doesn't allow any part of an object to move below the plate plane. Allowing objects to go below the plate, like in Cura, will save time in situations such as testing out overhang, or reprinting part of a big model that previously failed at a certain height. In these cases, the lower part of the model doesn't need to be printed.
The text was updated successfully, but these errors were encountered: