Currently only supported for Taranis X9d+ and opentx-2.3! It looks as if edgeTX is also working but I did not yet change to edgeTX. (But I will do it soon) based on ideas of Frank Schreibers F3F Tool This version is modularized as much as possible.
- Center is a course library which raises IN/OUT events on two bases. (Three bases may be possible in a future version)
- These events are consumed by a competition module which starts the appropriate actions depending on the actual competition status.
- The GPS sensor is encapsulated in a separate module to enable the same interface for different sensors.
- The setup is a pain on the Taranis. A simple blocked screen has been developed to take care of that.
- The main loop is collecting data from the sensors and updating the cours and competition. (since there are no real events in a single threaded environment)
- use
S1
to change the course bearing - use
S2
to change the competition type - use
rud
left/right to change the base A location (F3F only) - use scrollbar plus/minus buttons to choose a predefined location.
- user
ENTER
to activate the changes from the setup screen.
- Wait until you have a valid GPS position
- F3F: Take you model and go to the center of the course.
- Take the cardinal direction from base left to base right from your mobile.
- Enter the value with slider
S1
- With slider
S2
choose "f3f" or "f3f_train" - With
rud
select if base A is left or right - If your model is in the center of the course press
ENTER
to activate the values. - Now you can go to the main screen by pressing
PAGE
- F3B: take your model and go to baseline A.
- Take the cardinal direction from baseline A perpenticular to baseline B from your mobile.
- Enter the value with slider
S1
- With slider
S2
choose "f3b_spee" or "f3b_dist" - If your model is on baseline A press
ENTER
to activate the values. - Now you can go to the main screen by pressing
PAGE
- To start the run push
SH
- Logger3 from SM-Modellbau.
- GPSV2 from FrSky. (Poor performance)
- F3F competition/training
- F3B Distance
- F3B Speed
Install the complete *.luac tree from the bin folder to your /SCRIPTS/TELEMETRY
folder on your SD-Card.
Compiling on the transmitter is not possible and you will get an out of memory
error.
- you need to install the setup.lua in one telemetry screen and the main.lua in the direct following one. (otherwise it may lead to script errors -- may!)