OpenZWave

plugin:    OpenZWave controller
author:    Bas van Dijk
category:  radio
version:   0.0.1
website:   http://domusto.com

Features

• Pair devices
• Emit device events
• Read device values / state

Hardware needed

• Vision Z-Wave Plus USB Stick ZU1401EU - € 29.95

Tested with

• Fibaro Smoke Sensor 2 FGSD-002 - € 64.95

Installing

DOMUSTO uses the node-openzwave-shared library. This library need you to have OpenZWave installed:

Raspbian

Install OpenZWave manually with:

wget "https://github.com/ekarak/openzwave-debs-raspbian/raw/master/v1.4.79/openzwave_1.4.79.gfaea7dd_armhf.deb"
wget "https://github.com/ekarak/openzwave-debs-raspbian/raw/master/v1.4.79/libopenzwave1.3_1.4.79.gfaea7dd_armhf.deb"
wget "https://github.com/ekarak/openzwave-debs-raspbian/raw/master/v1.4.79/libopenzwave1.3-dev_1.4.79.gfaea7dd_armhf.deb"
sudo dpkg -i *openzwave*.deb

More info: https://github.com/OpenZWave/node-openzwave-shared/blob/master/README-raspbian.md

Ubuntu

More info: https://github.com/OpenZWave/node-openzwave-shared/blob/master/README-ubuntu.md

Installation

$ ./domusto.js plugin install basvdijk/domusto-zwave

Configuration

1. Connect the Vision USB stick to your usb port
2. Add the section below to your config.ts
3. Set the correct com port where your have connected your Vision USB stick
4. Restart DOMUSTO

{
    enabled: true,
    debug: true,
    type: 'ZWAVE',
    settings: {
        port: '/dev/ttyACM0',
        pairingMode: false
    }
},

Paring mode

When you enable pairingMode the plugin listens for new devices to pair.

Paring devices

Fibaro Smoke Sensor 2 FGSD-002

• Make sure you have pairing mode enabled
• Wait till discovering is complete and Paring mode active is shown in the terminal
• Hold the button on the smoke detector, release when you hear a beep.
• Press 3x shortly on the button on the smoke detector