CP2130 Configurator (cp2130-conf) is an application that can be used to configure CP2130 devices, including VID, PID, as well as other descriptors. Most importantly, the application allows you to configure pin functions and states.

FAU201 GUI is a graphical interface for the FAU201 Power Supply. It works by invoking commands, which in turn control the function generator. Thus, being only a front-end, it requires the commands to be installed in order to have an effect.

FAU200 GUI is a graphical interface for the FAU200 Power Supply. It works by invoking commands, which in turn control the function generator. Thus, being only a front-end, it requires the commands to be installed in order to have an effect.

GF2 GUI is a graphical interface for the GF2 Function Generator. It works by invoking commands, which in turn control the function generator. Thus, being only a front-end, it requires the commands to be installed in order to have an effect.

GF1 GUI is a graphical interface for the GF1 Function Generator. It works by invoking commands, which in turn control the function generator. Thus, being only a front-end, it requires the commands to be installed in order to have an effect.

CP2130 Commander (cp2130-com) is a graphical application that can be used to control and interact with CP2130 devices. Among other tasks, it allows you to perform SPI writes and reads, while also providing a way to monitor and control GPIO pins.

Additional morse command for the GF2 Function Generator. This command utilizes the function generator to signal messages either in audio-frequency or in radio-frequency CW mode.

A C++ class that uses libusb to interface with MCP2210 devices. It can be used to control the several aspects, such as NVRAM or volatile configurations, GPIO directions and states, or to perform SPI transfers. Note that this is a class variant made specifically for Qt. If you wish to use the original, non-Qt variant, please refer to https://gith…