You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Someone posted a photo of this area on the board asking for clarification on the cut points. In the guide lists the following information:
"cut traces for R', G' and B' right before the MultiAV (but behind C44, C46 and C47)"
However, C46 goes into pin 3, not pin 4, and the ceramic cap for it is a different color. Just visually inspecting the photo, I suspect C44, C45, and C47 are the RGB ceramic caps. Might want to double-check this to make sure.
The text was updated successfully, but these errors were encountered:
Firebrandx
changed the title
RGB lines to cut for SVHC-CPU-01 may be incorrect
RGB lines to cut for SHVC-CPU-01 may be incorrect
May 20, 2022
Thanks @Firebrandx (I'm the same guy from FB you were helping) I succesfully installed the board and took photos. Another thing I would change on the instructions is: When it says to install the SMD resistors on the board, it just says install, nothing mentioned about removing the original components. So It should say remove & then install the parts, otherwise people might think they need to stack them or something.
Board before removing SMD resistors:
Board after removing SMD resistors:
New SMD resistors are installed:
Isolate the rear of the bypass board with kapton tape:
Install the bypass board:
Install the R, G & B wires:
Someone posted a photo of this area on the board asking for clarification on the cut points. In the guide lists the following information:
"cut traces for R', G' and B' right before the MultiAV (but behind C44, C46 and C47)"
However, C46 goes into pin 3, not pin 4, and the ceramic cap for it is a different color. Just visually inspecting the photo, I suspect C44, C45, and C47 are the RGB ceramic caps. Might want to double-check this to make sure.
The text was updated successfully, but these errors were encountered: