You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Name of SD card you tried to flash (some are too slow or too small) | SanDisk Ultra 256GB Micro-SD
What day you first downloaded wor-flasher | 1/25/24
What linux operating system you are using to run wor-flasher on. (Raspberry Pi OS, Twister OS, Debian, etc) | Raspberry Pi OS 32-bit
Procedure:
Tell us what you did, step by step. Be specific enough so that one of us would be able to replicate your setup.
(I was using an ethernet cable if this changes anything)
Put the command to download "Pi Apps" in the terminal
Opened Pi apps and clicked on tools and the "wor-flasher" and then clicked install
Clicked on the raspberry pi icon in the launcher and then went to accessories and then I clicked on wor-flasher
Launched wor-flasher and then from the startup screen I clicked windows 11 and raspberry pi4/400 then I hit next
After it found the best windows version I chose my language (en-us) then I hit next
Then I hit next after the micro-sd card popped up as a storage option. I hit nest
Then I hit flash
after a few seconds I get this error message "An error has occurred:
PE-based installer integrity check failed
Exiting now." and I hit ok. Then the popup disappears and It shows the terminal with the same message.
What should I do?
The text was updated successfully, but these errors were encountered:
Setup:
Procedure:
Tell us what you did, step by step. Be specific enough so that one of us would be able to replicate your setup.
(I was using an ethernet cable if this changes anything)
PE-based installer integrity check failed
Exiting now." and I hit ok. Then the popup disappears and It shows the terminal with the same message.
What should I do?
The text was updated successfully, but these errors were encountered: