V2.0.B3

V2.0.B3

REQUIRED Printer Firmware: V1.1.B3.3

Added full SD Card browsing including folders and thousands of files
Enabled Linear Advance
Fixes for Touchscreen glitches

Please note that if you are using OctoPrint and want proper status updates on the touchscreen, you should set up your GCODE settings like on this page.

V2.0.B2

V2.0.B2

REQUIRED Printer Firmware V1.1.B2

Adds Auto-Tramming feature
Sets hotend offset values to 0.01mm
Fixes for OctoPrint
Fixes for filament runout
Fixes for mode selection and icons
Fixes for EEPROM saving

v2.1

This release has the following changes:

• Adds a 100mm option in the "Move" menu
• Disables touchscreen beep
• Enables screen dim after 5 minutes (tap to wake up)

Extract the ZIP and put the extracted "DWIN_SET" folder on the root of your MicroSD card.