This repository has been archived by the owner on Feb 21, 2024. It is now read-only.
-
Notifications
You must be signed in to change notification settings - Fork 11
Ordering Parts & Supplies
Charles K Stevenson edited this page Aug 15, 2017
·
1 revision
- MG Chemicals No Clean Flux Paste, 10 ml Syringe
- MG Chemicals Leaded Solder Paste, Sn63/Pb37, No Clean, 1.2 oz Syringe
- 63/37 0.3mm rosin core solder
- Kapton tape (optional) can be used to hold down F4 chip when hand soldering
- Hakko 599B-02 Solder Tip Cleaning Wire and Holder
- 2-in-1 SMD Hot Air Rework and Soldering Iron Station
- Solder wick
- Heat shrink tubing of various sizes
- Helping hands with several layers of heat shrink covering the teeth to prevent damaging PCB
- ESD Precision Anti-static Tweezers
- 91% or higher Isopropyl Alcohol (IPA) for cleaning
- Natural fiber paint brush for cleaning flux from board with IPA (plastic brushes melt if the board is still hot)
- Power towels and/or Kim Wipes for cleanup up flux with IPA
- Old toothbrush for removing stubborn flux from board
- Digital Multimeter with continuity function very handy (e.g. Fluke brand)
- Fluke TP88 Rigid Back Probe Pin Set, 2" Length piercing probes (sharp fine point)
- 10x or greater magnification for close visual examination of solder pads etc
- JST-PH 2.0 Pin Male Female Connector Cable Kit for Blade Inductrix Battery Upgrade
- Double-sided tape for mounting receiver and FPV camera
- Electrical tape to put on PCB before using double-sided tape for cleaner removal
- Rubber band for holding down FPV camera