Skip to content

Enclosure Assembly

Jump to bottom
Matthias edited this page Jun 11, 2019 · 4 revisions

Use the following guide as a reference when assembling your HKCam enclosure.

The enclosure is 3D printed with PLA filament, which is brittle. A printed part may break if you apply too much pressure or throw on the floor. So please deal with it gently.

  1. Put the Raspberry Pi Zero W into the body. There is actually only one way to put it.
Insert Raspberry Pi Zero W
  1. Put the camera module into the designated slot. If you have a long camera cable, you can bend it slightly to fit into the case.
Insert camera module
  1. Put the lid on the body. The lids has 3 beams (?) which fit into the slots in the body.
Lid beam Lid beams

Try to put your fingernail between the lid and the body to put the last beam into the slot. Lid beams

If your camera module v1.3 doesn't fit into the camera hole, please checkout this issue.

Clone this wiki locally