Diagonal travel

[steersteer]

Hi, I'm having some trouble with this extension.
On the manual control tab, "walk carriage (X)" or "walk carriage (Y)" makes the plotter travel diagonally.
Also, is there a way to set the origin of the tool or does it default to top left or right etc?

[bullestock]

It sounds as if your GRBL is not configured for COREXY.

…

On Sat, 23 May 2020, 14:01 steersteer, ***@***.***> wrote: Hi, I'm having some trouble with this extension. On the manual control tab, "walk carriage (X)" or "walk carriage (Y)" makes the plotter travel diagonally. Also, is there a way to set the origin of the tool or does it default to top left or right etc? — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub <#12>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AAAVDH7ZUSFPFPQH7WQUWKDRS63IRANCNFSM4NINKGRA> .

[steersteer]

Well I used misan's gbrl version and verified the "#define COREXY // Default disabled. Uncomment to enable." is uncommented in the config.h.
X and Y work as normal in universal gcode sender too