Hardware-Design-Lab

This repo is "NTHU Hardware Design & Lab" course project.

FPGA Design Enviroment

Xilinx Vivado & Basys3 Demo Board

Lab1 1-bit and 4-bit ALU

Use combinational circuit to module a Arithmetic Logic Unit (ALU).

• Lab1_1: use structural modeling to module a 1-bit ALU
• Lab1_2: use data flow modeling to module a 1-bit ALU
• Lab1_3: use behavioral modeling to module a 1-bit ALU
• Lab1_4: cascade 4 of 1-bit ALU to module 4-bit ALU

Lab2 1-digit BCD Counter

Use sequential circuit to module a 1-digit BCD counter.

• Lab2_1: use combinational circuit to convert 1-digit BCD number to its next/previous BCD number
• Lab2_2: write a testbench to verify Lab2_1
• Lab2_3: use sequential circuit to design 1-digit BCD counter

Lab3 Clock Divider and LED Controller

Module your design on FPGA demo board to control the LEDs as requirement

• Lab3_1: module a LED controller as requirement
• Lab3_2: rewrite Lab3_1 by adding a speed selection signal to speed up/down the light frequency

Lab4 BCD and Pingpong Counters

Module a BCD/Pingpong counter on FPGA demo board to control the 7-segment display as requirement

• Lab4_1: module Lab2_2 to the FPGA on demo board
• Lab4_2: extend Lab4_1 from 1-digit to 2-digit
• Lab4_1: module a 2-digit pingpong counter to the FPGA on demo board

Lab5 Ticket Machine

Module a controller for a ticket machine on FPGA demo board as requirement.

Lab6 Ticket Machine(2)

Modify your lab5, there will be some specific key combinations of the keyboard that represent the buttons of a ticket machine on lab5.

Lab7 Music Player

Design a music player that is able to play eight bars (measures) of "Chibi Maruko Chan - OP" and four bars (measures) of "Doraemon - OP".

Lab8 VGA Display

Design a circuit for controlling the VGA display as requirement.