funiculi [FLAGS] COMMAND
COMMAND
is one of the following:
off
: Turns the device off.
on
: Turns the device on.
down
: Turns the volume down one step.
up
: Turns the volume up one step.
source [get | set NAME]
: Selects or queries the audio source.
The get
subcommand returns the current source.
The set
subcommand accepts a source name according to Denon’s
protocol; the name is case-insensitive.
Acceptable values vary by model. To find out the values for a
specific model, omit this parameter while your device is set to a
known source. Repeat for each source.
status
: Queries whether the device is on standby.
dlna
: Sets up a local virtual output device that relays all audio to the
: receiver via DLNA.
The following flags are supported:
The AVR host to connect to.
Mandatory if no AVR_HOST
environment variable is defined.
The parameter takes precedence over the environment variable.
The AVR control port to connect to.
The default is 23.
The AVR web port from which to obtain DLNA metadata.
The default is 60006.
The timeout for commands in milliseconds.
The default timeout is 100 ms.
The remote path to the UPnP XML descriptor.
The default value is: /upnp/desc/aios_device/aios_device.xml