You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
When using the genuine acro board and the latest SP-F3 hex in the latest clean flight an external baro (BMP180) is not being recognized, tried a few different boards to make sure its not the external board that is faulty. Attempted to manually set the board type using the CLI but still no joy.
The bmp180 boards not being seen by the SP-F3 board using the latest hex are automatically found in cleanflight using both a flip32+ and a Naze32 Rev 5 FC's. Tellingly when the SP-F3 is flashed with the correct version of the "iNav" firmware the external BMP180 is recognized instantly.
The text was updated successfully, but these errors were encountered:
@matevz25: This has long been released in an official version of cleanflight. Just use the cleanflight configurator to update your board to the latest firmware.
When using the genuine acro board and the latest SP-F3 hex in the latest clean flight an external baro (BMP180) is not being recognized, tried a few different boards to make sure its not the external board that is faulty. Attempted to manually set the board type using the CLI but still no joy.
The bmp180 boards not being seen by the SP-F3 board using the latest hex are automatically found in cleanflight using both a flip32+ and a Naze32 Rev 5 FC's. Tellingly when the SP-F3 is flashed with the correct version of the "iNav" firmware the external BMP180 is recognized instantly.
The text was updated successfully, but these errors were encountered: