New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
CC3D - unable to connect via USB #726
Comments
You need to use some drivers if you don't use open pilot: |
I have the same problem on my Mac. Is there a similar driver I need to install? |
Thank you dascons i installed the driver as explained and no luck.... |
i tried connecting it to my Mac no luck... |
jamieharwood |
Power up the FC using its USB port via your PC/Mac. If you have the driver installed your computer would detect the FC and allocate a virtual com port. Then open the Chrome based CleanFlight Configurator. |
both the usb cable and the lipo have to be connected. Without lipo, my cc3d will not connect either. |
I've made a small Video on installing Cleanflight on CC3D. Read also the description and comments. Cleanflight on CC3D is a bit tricky to handle, but if you follow the instructions all works fine. |
Hi guys, |
No problem, first connect with battery plugged. Then unplug battery, the USB connection will remain active! Go to Motor Tab and synchronize as usual. |
Thanks FranzAr, unfortunately it's my stupid day. Trying to synchronize my Emax Simonk ESC with the throttle, I made a mistake and set the ESC to bidirectional. Now it seems I can't enter the program mode, the security doesn't allow me to start throttle up... I'm stuck... ;( thanks anyways |
Removed unnecesary #includes from drivers
MagHold controller reset on arm and MAGHOLD enable
hello i have a cc3d and i connected the battery and openpilot is discontinued and my CC3D wont connect to cleanflight |
Got a new board from fpvmodel.com flashed with. Cleanflight 1.8 stable can not connect via usb i am using win 8.1 64 the led light on the board is orange no issues in devices on the pc. The pic make a sound that a device is connected no error but the software can not find the board
The text was updated successfully, but these errors were encountered: