You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Same issue when sending gcode over the usb port via Printrun. Using TeachingTech's generated gcodes.
Again, it triggers the filament runout error only with the first gcode i send, then after aborting once it goes straight forward.
Enabled in configuration.h file when building the firmware, using same old gcodes, and it does not give any error with the latest firmware.
Thank you for your work, I wish I could help more :)
Description
Same as issue #7 , but with latest release available. After aborting and then starting the print again, it goes on flawlessly.
Additional Information
Using start/end gcode found on r/CR6's wiki , using Cura 4.7.1 with printer profiles downloaded from Cura's github.
The text was updated successfully, but these errors were encountered: