Update safe/config mode instructions in README.md #41
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
README.md still referred to pulling pin 10 to GND and power cycling to
enter safe/config mode. Changed this to pin 0 to match the code change
in commit eec7414.
Also mentioned that "config mode" is the same as "safe mode" since both
terms are intermixed in the code and documentation.
I have also updated the reference to the safe/config mode pin on the wiki
at http://digistump.com/wiki/oak/tutorials/arduino