-
Notifications
You must be signed in to change notification settings - Fork 9
Hardware test log
Drive Badger is developed and periodically retested on our own hardware.
Additionally, we are sometimes permitted to test it on other hardware. Below you can find logs from such tests.
Tested in March 2021. Found problems:
- no USB 3.0 (UASP on USB 2.0 still worked), this is a known problem
- Kingston DataTraveler G3 pen drives (3 different pieces) were not recognized (SanDisk Extreme Portable SSD and PNY Elite Portable SSD were recognized properly on both front and rear USB ports), this is a known problem
- graphical mode didn't work (crashed the whole machine before X finished loading)
- LSI MegaRAID SAS 1078 didn't properly reported SMART for drives - drive serial numbers were not recognized, but it didn't affect the functionality
Tested in April 2021. Found problems:
- both USB 3.0 ports on the right side work improperly with USB Storage devices under Linux and cannot be used to boot Drive Badger, this is a known problem
- in graphical mode, built-in touchpad doesn't work (this is a common issue for MSI laptops)
Tested in April 2021. Found problems:
- drives were not spinning, most probably there was no power in the drive cage (effect of breaking in to the case?) - this was probably related to lots of errors referencing very similar device number, as topology visible in
/dev/disk/by-path
- P410 controller reported itself empty
- however 2 RAID1 devices were visible in
/dev/disk/by-path
, but inaccessible when trying to access them
Tested in April 2021. The only found problem is the one descibed here (V14-IIL is an Ideapad model without Novo Button, without classic boot menu).
Tested in April 2021. Found several problems:
- no LUKS support
-
Intel GMA 950 has problems supporting WQHD and 4K monitors - HDMI signal is switching off right after loading
gma500
Linux kernel module (after boot, but before asking for LUKS password for persistent partition)
Tested in June 2021. All 3 USB 2.0 ports didn't allow booting from USB device (tried 3 different devices: SanDisk, PNY, Kingston), even when properly configured in BIOS, and the same devices were visible by preinstalled Windows 7.
Tested in June 2021. Found problems:
- in UEFI boot mode, Kali Linux Live in both 32/64-bit variants is completely skipped during boot, and also not seen in boot menu - booting Drive Badger requires going into UEFI settings and changing boot mode to Legacy (this is a problem, since UEFI settings can be password protected)
Tested in September 2021. Found problems exactly as in the above MSI Leopard GL75 10SCXR.
Tested in December 2021. Found problems:
- several problems with recognizing network interfaces and DHCP on current Linux kernels (solution: install
firmware-linux-nonfree
package, duplicateeth0
orenp0s*
entries in/etc/network/interfaces
file for interface nameenp2s0
) - specific method of internal drives enumeration on G7 in connection with LUKS-encrypted drives, make Kali Linux in Encrypted Persistent Partition mode to ask for LUKS passwords for these drives first. Kali won't start, until you enter the proper LUKS passwords for all such drives, or disconnect them. You need to reconnect them right after entering LUKS password for your persistent partition, to allow them to be detected when Drive Badger starts.
Tested in March 2022. No problems affecting Drive Badger functionality in any way, however handling of USB NVMe drives (Samsung T7, properly connected to USB 3.0 port using original cables) was noticeably slower than non-NVMe ones.
© Copyright 2020-2022 by Tomasz Klim Payload.pl