Legacy Brush Flags
A brush can have several flags which change the behavior of the brush and the placement of the schematics. All flags have a short form.
A schematic can be placed in several method. Before a schematic is placed, we modify the origin of the schematic. The origin position is equal to the block you pointed at with the block. The origin is always at the x and z center of your schematic, but we allow you to change the y value which is most important.
Middle: The origin will be in the y center of the schematic Bottom: The origin will be on the lowest point of you schematic Drop: The origin will be at the lowest non air block in your schematic. This is the default value. Top: The origin will be on the highest point of you schematic Raise: The origin will be at the highest non air block in your schematic
-placement:type
-place:type
-p:type
Hint you can also use only the first letter of the type. This means that: -p:d is equal to -placement:drop
The y offset is applied after the placement changes. You can raise or lower a schematic before pasting. This is useful for trees if you want be sure, that they will not be placed on top of gras.
-yoffset:number
-yoff:number
-y:number
On default the schematic brush only replaces air. We don't want to destroy existing structures. This will change the behavior. So we can replace blocks, which are solid.
-replaceall
-repla
-r
On default we don't place air block. If you want to change this use this flag.
-includeair
-incair
-a