3000# ESP32 LogicAnalyzer A SUMP compatible 16Bit Logic Analyzer for ESP32 MCUs.

• Use Arduino to compile and flash your ESP32.
• Uses ESP32 I2S DMA and could capture speeds up to 20 Mhz.
• Support 8 bit and 16 bit operations.
• Maximum 128k samples. (Even using 8bit capturing mode.)
• RLE compression supported.
• Analog input is NOT available.
• WROOVER modules support 2M samples but only up to 2 Mhz due bandwith limit on PSRAM access. Under development.
• Default OLS port is UART0 and default baudrate is 912600.
• You can use UART2 for high speed OLS communication by using USE_SERIAL2_FOR_OLS macro at ESP32_LogicAnalyzer.h file. Default OLS baudrate is 3M on this mode.
• WARNING:
  • For OLS port at UART0
    • Please pull GPIO15 to ground (this will silence boot up messages.)
    • Set "Core Debug Level"=None before compiling code at arduino.
  • Set "Core Debug Level"=None for > 10Mhz capture operations.
  • GPIO23 used for I2S input clk. Don't use it for IO or change it to an unused pin from code.

If you like it, why not to say thanks or support via Patreon

This project steals some code from esp32-cam-demo for I2S DMA and Arduino Logic Analyzer as SUMP protocol "template".