Skip to content
[Absolete!!! Use CF/BF BB firmware!!!] Blackbox firmware for the OpenLog hardware
Branch: master
Clone or download
Pull request Compare This branch is 4 commits ahead of cleanflight:master.
Latest commit 7363bf0 Jan 28, 2017
Permalink
Type Name Latest commit message Commit time
Failed to load latest commit information.
OpenLog_v3_Blackbox Disable sleep mode... Jun 11, 2016
binaries
libs
utils
.cproject Update to latest SdFat and SerialPort libraries Feb 15, 2015
.gitignore Add .gitignore for Eclipse project files Feb 15, 2015
Makefile Update to latest SdFat and SerialPort libraries Feb 15, 2015
Readme.md

Readme.md

Blackbox firmware for the OpenLog

This modified version of OpenLog 3 Light modifies the "CONFIG.TXT" system that is normally used to configure the OpenLog in order to simplify the available settings and ensure it is compatible with the Blackbox. The only available setting in CONFIG.TXT is the baud rate, which defaults to 115200.

You will find a zip file containing the required libraries, the source-code and the compiled hex file on the "releases" page above.

You'll need to copy the required libraries to your Arduino IDE's library path in order to build this from source. Copy the inner libs/SdFat-master/SdFat and libs/SerialPort-master/SerialPort folders to your libraries folder directly (don't copy the outer folders SdFat-master/ or SerialPort-master/.)

To flash the firmware to the OpenLog, you can use an FTDI programmer like the FTDI Basic Breakout along with some way of switching the Tx and Rx pins over (since the OpenLog has them switched) like the FTDI crossover .

If you are using the FTDI USB to TTL cable you must also connect the DTR/RTS pin (green wire in my cable) to the hole labeled "GRN" on the OpenLog. This is what Arduino uses to cause a reset on the processor so programming can begin.

In the Arduino IDE, choose the "Arduino Uno" as your board and select your serial port (if you use an FTDI cable) or your programmer if you're using one. Then click Sketch -> Verify/Compile and File -> Upload (if using FTDI do not choose upload using programmer) to send it to the OpenLog.

You like what I do and want to support feel free to donate

You can’t perform that action at this time.