You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I connected PWM outputs of a RC receiver to specified pins and tried playing with calibration pin, but controls won't move in processing or in USB mode
If I enable debug mode -- I get Setting controller data by serial and some number (which I assume are actual stick positions, for example), if I pull calibration pin down -- I get Calibrating data which disappears as soon as I stop pulling it low
I am a bit confused about all this so I'll greatly appreciate a little manual
Thanks!
The text was updated successfully, but these errors were encountered:
On Sun, Feb 7, 2021, 5:01 AM WallK ***@***.***> wrote:
Could you write a small usage instruction?
I connected PWM outputs of a RC receiver to specified pins and tried
playing with calibration pin, but controls won't move in processing or in
USB mode
If I enable debug mode -- I get Setting controller data by serial and some
number (which I assume are actual stick positions, for example), if I pull
calibration pin down -- I get Calibrating data which disappears as soon as
I stop pulling it low
I am a bit confused about all this so I'll greatly appreciate a little
manual
Thanks!
—
You are receiving this because you are subscribed to this thread.
Reply to this email directly, view it on GitHub
<#2>, or unsubscribe
<https://github.com/notifications/unsubscribe-auth/AAJNGX5O6RCWZ63P7JLLKNDS5ZXJVANCNFSM4XHKPXRQ>
.
Could you write a small usage instruction?
I connected PWM outputs of a RC receiver to specified pins and tried playing with calibration pin, but controls won't move in processing or in USB mode
If I enable debug mode -- I get Setting controller data by serial and some number (which I assume are actual stick positions, for example), if I pull calibration pin down -- I get Calibrating data which disappears as soon as I stop pulling it low
I am a bit confused about all this so I'll greatly appreciate a little manual
Thanks!
The text was updated successfully, but these errors were encountered: