-
Notifications
You must be signed in to change notification settings - Fork 147
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
"Can't write to TMC SPI "stepper_x/y/extruder register, GLOBALSCALER error" #40
Comments
Board works fine with TMC2209 drivers in UART. Also works fine with a PT100 step stick in SPi mode.. Just won't work with 5161 drivers. |
Resolved. Faulty drivers. |
got the same issue but with new drivers but on all axis
|
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Getting this error..
Example of my configs
[stepper_x]
step_pin: PE11
dir_pin: PE10
enable_pin: !PE9
microsteps: 16
rotation_distance: 40
endstop_pin: PB14 # PA1 for X-max
position_endstop: 0
position_max: 485
[tmc5160 stepper_x]
spi_bus: spi4
cs_pin: PE7
diag1_pin: PB14
run_current: 1
hold_current: 0.8
stealthchop_threshold: 0
interpolate: True
Tried different steppers in X leaving the others blank s (alternative 5160's) . This was working fine in my S6 V2.
Trying to do anything with the stepper driver with TMC5160 drivers causes Klipper to shutdown.
4 jumpers in the bottom positions on the driver slot, as per Spider Github.
The text was updated successfully, but these errors were encountered: