CalibrationCompanion breaks Spoolmanager

[GylRon1]

After installing CalibrationCompanion it is impossible to add new spools in Spoolmanager. If it is disabled and Octoprint is restarted, adding spools is possible again. I have Themeify installed. Attached an empty spool adding screen grab (the error) and a correct working screen grab.

[iFrostizz]

Do you have any error in the devtools (F12) when calibration companion is enabled ? Usually this is a conflict between Ids, or some kind of knockout bindings

[GylRon1]

Sorry, I'm not the smartest when it comes to programming, I don't know where to find the devtools (F12). I'm working with the Chrome browser if that can help?

[iFrostizz]

Just enable Calibration Companion, go in the SpoolManager tab (where it's broken), and press "F12". Here, a tab should open, and head on "Console". There might be some errors in red. If so, please provide me a screenshot

[GylRon1]

Here you go.

[iFrostizz]

I don't think that this is the error I'm searching for, I see that they are 33 errors

Do you spot anything else ?

[GylRon1]

Hello iFrostizz, the other errors were network related. I prepared another Raspberry Pi (4B 8GB) with latest octopi and newest Octoprint with the same plugins and notice the same problem. I don't have a printer attached, but tested on my regular Octoprint that it does not matter for the error to occure. I have attached the console output on the fresh install. There are no other errors, only 6 warnings. Hope this helps.

[iFrostizz]

Thanks, it was a css issue from my plugin. I'm gonna publish an update soon

[GylRon1]

Thanks for looking in to it. I appreciate all you guys for the work you do and making this all possible for us (the lesser gifted in programming)!

[GylRon1]

Nice, Spoolmanager seems to work properly again after your correction. Keep up the good work, Best regards, Ronny. Op ma 17 mei 2021 om 10:05 schreef Guyot François ***@***.***

…

: Closed #7 <#7>. — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#7 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AUCA4MQX76G3Q425NJ2QILTTODE43ANCNFSM443DM6PQ> .