You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Check these boxes if you have followed the posting rules.
Q&A General is the most appropriate section for my question
I have consulted the posting Guidelines on the Discussions front page
I have searched the Discussions forum and my question has not been asked before
I have searched the MOOSE website and the documentation does not answer my question
I have formatted my post following the posting guidelines (screenshots as a last resort, triple back quotes around pasted text)
Question
Hello,
I have a fluid mechanics background and I am new to MOOSE, I have seen the tutorials and searched the application website but I am still unsure if the problem I have can be simulated with MOOSE.
I have a stationary and a rotating object (rotating at high RPM) with a very small gap in between. I have searched for FE analysis in Moose but I am unsure about the contact and how to set it up when one object is rotating (to prevent clash) and the mesh is deforming.
I appreciate if you can let me know in case this type of simulation is possible in MOOSE and give me some directions.
/Mali
Check these boxes if you have followed the posting rules.
Question
Hello,
I have a fluid mechanics background and I am new to MOOSE, I have seen the tutorials and searched the application website but I am still unsure if the problem I have can be simulated with MOOSE.
I have a stationary and a rotating object (rotating at high RPM) with a very small gap in between. I have searched for FE analysis in Moose but I am unsure about the contact and how to set it up when one object is rotating (to prevent clash) and the mesh is deforming.
I appreciate if you can let me know in case this type of simulation is possible in MOOSE and give me some directions.
/Mali
Originally posted by @malih1186 in #27717
The text was updated successfully, but these errors were encountered: