Modifications for Voron 1.55 Machines
https://www.reddit.com/r/voroncorexy/
Those changes were made to try to reduce costs, maintaining quality and improving all-round stiffness in the frame and gantry.
All files are modified from MZBot / RussiancCatFood original files(https://github.com/mzbotreprap/VORON) and Volcom8190 Voron Mods (https://github.com/mzbotreprap/VORON/tree/master/Mods/Volcom8190) adapted for 3030 aluminum profile,12mm Chinisium polymer bearings, 12mm Gantry (XY) and 8mm Z.
Note: 12mm chinisium polymer bushings dimensions (L30mm, OD21mm, ID12mm – OD is smaller then the original igus bushings)
The use of 12mm aluminum hollow tubes ( extrusion ) is advised to prevent binding.
Some parts are intended for 300x300mm print area : (bitolas – (gauges) files for the alignment of the Z vertical rods in the all metal version.)
These files allow the following:
- Full metal Z supports( with alignment stl’s available) , and/or full metal bed frame with a bed plate design available. -12mm were its most needed (xy). A revised carriage adapted for 12mm chinese “igus”, e3d V6 and bltouch from volcom8190 carriage files.
- Full metal Z suports with the use of Steel 8mm SK8 Linear Bearing Rail Shaft Guide Support Bracket ( aligned with the “ bitolas “ files ). An extra extrusion needs to be added to the frame were this will attach. This also adds improved stiffness to the frame.
- Design for a full metal bed frame, supported vertically by LMF8LUU bearings attached to the bed frame.
- jbaiao
- Yougurt